Marks the seconds as part of the time shown on the watch.
Measures seconds on the chronograph.
Measures minutes on the chronograph, up to 60.
To change the time, pull out the crown, with care. When you finish, push it back into position, to make sure the watch stays waterproof.
The chronograph that counts seconds starts moving. It marks off each second and takes a minute to do a full circle.
The chronograph stops and stays in position. When you activate the chronograph again, it keeps moving from where it stopped.
Put all chronographs into their initial position.
The chronograph stops and stays in position. When you activate the chronograph again, it keeps moving from where it stopped. If the chronograph hand doesn’t return to its original position at zero (12 o’ clock) when you reset the counter, pull out the crown and push the button until you manually put the hand in place. Close the crown.